How to install the sink in the bathroom
Installing the shell is not a difficult task, not necessarily have to be a plumber - sure, such a problem you can solve yourself.
Remove the old sink
Before dismantling Washbasin shut off the hot and cold water. Then remove the old sink. Using wrenches twist with washbasin mixer (crane). Do this carefully, if the mixer will be placed on a new sink. Do not damage the supply tube mixer. Save, but rather replace all gaskets. Remove the siphon from the old baths. I recommend to replace the old drain trap to the next, or simply replace the gaskets.
marking
Now you need to make a layout. To do so, the future sink into place. Draw a line along the upper edge of the basin. All work is done with a level, to sink stood straight. This way you can find out where to make holes for the sink mountings.
Checking water compounds
The important point, your drain siphon must get into the pedestal that comes with sink (in case if you bought a wash basin with pedestal, not cabinet with sink). After the sink is installed it is screwed into the new drain trap, mixer (crane).
Siphon drain
If your sink has a hole for the overflow, you need to buy a siphon drain with overflow. In conventional shells through hole not overflow, water is poured into a central drain.
chink
At the end of sink installation, gloss over the gap between the sink and the wall. For this you need a plumbing sealant (white, transparent).
Now you can open the hot and cold water and you can use the new sink. You can start install a mirror in the bathroom room.