The national team of the bed to give details with photo

Not having your own apartment or house, people often have to relocate. And while moving heavy bed become a real burden. Get out of such situations will help design, to build which would require only a few screws and bolts. This bed can be easily bypassed, even without glue. The whole process of assembly and disassembly of such a design in minutes and does not require the owner's special skills or knowledge. And for a future bed should be allocated no more than four hours.

The whole process is divided into 7 steps.

The national team of the bed: Preparation of material

To create the bed will need to prepare the following:

• tools for joinery: handsaw, jigsaw and the like;
• 20 bolt;
• board corresponding to the growth of those who will use the bed. One can take, for example, the size 250h150h3000 mm;
• wooden pole diameter of 15 mm. The length is chosen based on the desired bed height;
• burner operating on propane and the fire extinguisher to prevent a fire.

We make measurements

Putting the board on all four sides of the mattress, they put labels. This can be done with the help of roulette.

Make a frame

According Markings made must be incised at an angle of 90 degrees to the board. How to do this is shown in the pictures. That the future framework to be strong, it is recommended to make cuts smaller than the depth of the marking. Then all the boards should be connected, using a hammer, since the arms to accomplish the task quite difficult.

The base for the mattress

Now you need to create a foundation on which then will be laid a mattress. For this purpose, on the inner side of the carcass bolted 2 boards. Thus they should be installed at a recess from the top of the frame equal to the thickness of the board. Following several cut into smaller boards and laid across the frame. As a result, you should get to the base lodge.

Making legs

The main burden falls on the legs. Therefore that which is able to withstand the weight of the bed, it depends on them.

Taking the prepared column, note the height. In this example it is 58 cm. Then it is cut to the required dimensions. Now incision workpiece so that the bed frame is firmly in each of them. Nicks must be done at an angle of 90 degrees.

Putting bed

If done so, as shown in the pictures, the bed at this point is almost ready. In the case where there are discrepancies, they should be eliminated.

Finishing bed

Turn on the burner and carefully burned everything of the bed. The process should be fast, otherwise the timber will light up.

Now you can put on the frame varnish or paint and allow to dry. All beds ready.

Liked? Like it!