Reinforcement of the mounting grid and the corners at warming the house

Before applying the final plaster, wall covered with foam, reinforced with a mounting net. Using glue mixture that was used for mounting the foam produce reinforcement, i.e. paving the mesh smoothing with a spatula and lightly plastered on top.

The process is shown in the photo:

• Measuring and cutting the mounting grid

• Adhesive coating the surface of the foundation wall

• Overlay mounting grid

• Smoothing trowel grid

• Gluing as a plaster

• Proarmirovannaya wall

However, mounting the grid can only be used for the flat surface of the walls. For reinforcing the corners - normal, embossed or window - special places are used. This device consists of lightweight due slits metal angle with the attached narrow tape mounting mesh.

In the photo - corner with mounting grid

Self reinforcing process exactly the same as already described:

• Measuring and cutting corner

• Drawing on the angle-adhesive

• Mounting brackets on the prepared surface
• Zashtukaturivanie corner

Fortified area corners of the house, window soffits, raised vystupyKstati, reinforcement of angles is performed before mounting overlay a grid on the wall.

I hope the article has helped you to deal with this issue. Laykni if ​​not difficult!