Laying flush (in the walls)

During the construction or repair of an opportunity to pad flush. This is the best possible moment so proshtrobit wall and thereby reduce the layer of plaster.

Council: Be sure to check the entire wiring, it can be done with an ordinary light bulb.

mount wiring

To begin, draw a line somewhere in your wiring will take place. It is necessary to consider all the lighting, as well as sockets and switches. Do not forget that the distance from the floor to the socket or switch was the same.

When markup is best to use a long spirit level to ensure that the lines are straight and perpendicular to the floor. It is also desirable to note the place where you will mount the wire.

Step 1. Mark the location of the wall boxes for switches and sockets.

Step 2. With the punch cutter with the nozzle drill holes for the boxes, then do Stroebe therebetween grinder.

Step 3. The boxes usually have mounting holes wires, they must break through. Then set the boxes in place and secure them with plaster.

Step 4. After the solution has dried securing box, wires can be laid. To do this, measure the required length of wire and protective corrugated, and set them in Stroebe.

Step 5. Stroebe and seal the edges of the plaster boxes.

Step 6. Wait until the solution has dried and can install sockets and switches.

Do not forget to straighten the cable before installation, try to avoid sharp bends.

Place Like if you like!