Cutting, grinding and circular saw grinders from his hands

In that narrative I was showing some nozzles and accessories for angle grinders and what is their value. For little money, you can extend the functionality of their grinders to set multiple instruments.

But some devices can be quite easy to make and very, turning grinder in a number of simple but comfortable machines that always come in handy in the shop or on a construction site.

We have thick veneer sheet. It installed mounting: rack that hold the rear of the LBM through the bearing assembly on the yoke. The front of the grinder rests on the area and is also fixed to the plywood. This is an easy way to do sanding or grinding machine.

Why bearing assembly? And in order to turn a quick movement in the cutting machine. Simply remove the area from the front. And in doing the plywood disk on wood cut. Visible right palm blanks.

If the structure to fix (the front of the LBM) in a certain position that would drive remains in the slot, and the sheet is turned over and set on legs, you get a miniature circular saw. Only work on it with blanks, which do not lead to biting disk. Metal (aluminum), I would rule out for the job. And observe the safety precautions!

How to assemble a machine 3 in 1, watch this short video:

You can simplify this mount, to get four corners at the hardware store and they fasten the bearing assembly.

Take a look a few more options for homemade frame and accessories for your LBM that will run on the grinding (or sharpening) and cutting machine:

The plate with welded rectangular pipe-shaped corners (or can be directly welded rectangular pipe 60x40 mm) - fasten thereto two brackets with holes for mounting grinder. The plate segment of a circular pipe is welded for fixing supports for workpieces stops. We fix grinders on two bolts and clamps "table-stand." All that can grind or sharpen (depending on stone or tips on the grinder). But also - observe safety precautions!

Next option - cutting machine for large and powerful angle grinders:

The base structure - a rotating mechanism of the truck. He bolted to the frame, and it is welded to the bracket for angle grinders. Between the frame and the bracket - the spring to return to its original position grinders. The workpiece is clamped too homemade clamp made of elongated nuts and studs on the same frame. You do not need hands to hold the workpiece.

On sale is a similar frame in China. But as they say in the comments - they have too much play and the quality of the saw cut turns low.

Another embodiment similar intended for trimming powerful LBM. Although something similar can be done for any size grinders:

Here, the main quality to make the hinge assembly - that he had not left-right backlash. This design is even simpler than shown above. But they all require a welder, drill. If you do not know how to cook - maybe it will be an occasion to make a machine and learn how to work with welding, welding inverter pre-purchasing.

Well, in conclusion, the option for a small angle grinders and power for those who do not want to mess with welding: cutting machine based on the mechanism of the hinge.

About the installation, everything is clear, even from two or three photos. But the need to modify the door hinge: insert the pin instead of the shaft and tighten it. This will reduce the backlash. For cutting at 90 and 45 degrees - you need to set the focus, the corner on the sheet frame (the best plywood, not particle board) in a pre-marked and drilled holes.

For light and media work will fit and a cutting machine. With frequent use of the wooden parts can become loose, should be altered to the new nodes. As described above, an important detail: the door hinge must be of high quality, with minimal backlash or no.

A short video as did the author:

I hope this article was for someone useful. Save link in the season it will be possible to make such devices outdoors in warm weather (if someone does not have a garage or workshop).

***

Photo taken from public sources, with Yandex service. Pictures

Subscribe per channel, introducing it in the browser bookmarks. There is a lot of interesting information.