Homemade putty: 7 secret formulations masters

The stores offers a variety of fillers. There is even a plaster on the mounting foam. But most of the interest in how to make plaster yourself. There are reasons. This desire to save money or make a high-quality, solid mixture. Make a plaster is possible and easy with your hands.

If to be minor repairs and fillers need not a lot, it makes no sense to buy her bags, buckets.

Putty for wood with their hands

Homemade putty is not inferior in quality to the factory putty. The first method: Crushed chalk diluted with PVA glue. We need to achieve consistency of sour cream. You can also add fine sawdust. But the rate of drying of such filler is not fast. Dries overnight.

The second way: Fine sawdust and chalk diluted nitrovarnish. Can be dyed in a desired color filler, adding color and gouache pigment putty. This putty dries quickly and strongly smells.

The third wayChalk and most inexpensive acrylic lacquer mixed and diluted with water, if it is thick. Kohler added if necessary. Caulking turns solid, elastic. You can add a bit of sawdust. Putty dries about 3-7 hours.

Still alternatively: linoleum pieces to fill in acetone. Linoleum dissolve and make a good filler for wood. The composition will be well protected from moisture.

Putty for painting, wallpaper

Carpenter's glue (15%) - 1 kg. connected to 10kg. chalk, turpentine, linseed oil hozyaystvennog and soap (25 g.). Stir thoroughly until smooth.

Casein paint (10 kg.) Mixed with water (7 L.). Heat the solution to 60 degrees. This is followed by drain and add to the composition of drying oil (300 gr.). After adding wet chalk (23 kg.).

Acrylic preparing a mixture of chalk, acrylic primer (10 kg.) And wood glue (2 l.). Mix all ingredients thoroughly.

Caulking almost as automotive strength

Mix the finish coating with PVA 801 and chemist glycerin. It turns out smooth, heavy-duty and sturdy coat. PVA glue must be diluted with water (1: 1). Connect with adhesive putty, putty to get the density you need. Glycerol is added to coat is not quickly dried up and cracked. Add to the eye. The more glycerin, the greater the plaster dries. Leave the mixture to stand for 5-10 minutes and then you can work.

channel RemontDom thanks for your attention. Place Like - thank you!