Modern heating system. Secrets of proper installation

Today more and more people opt for baseboard heating. Bulky baseboard heating systems are inferior compactness, convenience, comfort. This heating is not evident, and looks natural. No cold zone above the floor - the feet will not get cold.

Warming up the room get even. Some faced the radiator to bring issues to the balcony. It is not allowed to do. But output is now - you can install infrared Baseboard heater.

Baseboard heater rather simple device and it can be done independently. This system is easier to maintain and with low weight, which is particularly favorable for the balcony. To repair in case of breakage easier.

There are three types of warm baseboards: electric, water, infrared.

often chosen electric warm plinth. For installation requires two or single-wire cable. In the electric versions are no filters, which become clogged over time and are not afraid of leaks. There are some types of warm skirting boards, which operate using the remote or SMS messages.

Electric embodiment requires summing up a power supply junction box. This plinth comprises a dry element within the copper tubes. Economically such heating can be achieved by using the thermostat.

Water plinth consists of a complex structure where the water is supplied from an electric or gas boiler. This system is cheaper than the electric version. But there is one significant drawback: the water baseboard can be done only on the first floor. The system does not differ from conventional radiators or radiators.

Infrared warm plinth - a kind of electrical systems.

A more modern version of heat. Power 150W. They use a special film for heating. The film thickness should be chosen 0, 4 mm. Infrared option plinth does not create light, not harmful.

He is also less expensive than the first option. But not all types of flooring can withstand the heat. Not suitable infrared skirting for parquet and other coverings, where the varnish is applied.

installation of a plinth

- Installation of the wall around the perimeter trims with self-tapping screws. The system is 10 mm. from the floor and 14 mm. from the walls. Between the wall and the housing Taine attached thermal insulation tape.

- Installation of the upper profile with fasteners.

- Connect modules in the overall system.

- Close the panel convectors.

channel RemontDom wishes of warmth and comfort in your house! Place Like, subscribe to a channel - thank you for your attention.