Cheap improvised device for cleaning the gun from the foam 5 minutes

The mounting foam is not seldom used in small household repairs. In order to apply the foam to various surface there is a special device - a gun. Using them is simple and easy. The gun used for closing large slit window, door and other openings.

Before the work need to remove dust and dirt from the surface. If the gap is large, it is recommended to close up its foam. This will reduce the flow of foam.

Moisten with water spray foam for better grip. Zapenivat better at least 5 g. If you need to work with the foam in a cold environment, the use frost-resistant foam.

You can not use a gun for foam. Some people use the phone, which often comes with foam for small repairs. But in this case, you will encounter many difficulties. Without a gun would be a big froth flow (in 2-4 times more). It is necessary all the time to control the press and the duration of the valve.

How to wash pistol from the foam?

2 syringes with solvent enough to flush the gun with foam. cleaner bottle cost for the gun - about

200 rubles. Balloon only enough 2-3 washing. Poor else that balloon is constantly flowing, "grass". Cost is not the cunning device near 5 - 10 rubles. solvent bottle costs only 646 50 rubles and it will last a long time.

After work, you need to wash the foam from the gun. If you do not want to spend money on expensive cleaners, that is one way, which is suitable for this.

Means for improvised foam cleaning cost is 5 - 10 rubles.

Cut the old bottle of - under the foam. Now clear the remnants of the dried foam. We will need the lid - the top of the cylinder. It is only necessary to break off valve inside the lid. Take a hammer and metal rod is pressed downwards.

Pliers remove sterzhenek. The tube should remain in the cover. It was the most complicated process. It now remains only to glue 20 ml syringe. He will close the valve and will hold fast. Pour hot glue connection cover and syringe. But you can not fill with adhesive. The device is ready after curing adhesive.

Fill the solvent into the tank top with the foam, which we will use again. Fasten our accommodation for the gun and begin to wash out. The syringe pour simple solvent (646) or acetone. Presses against the rod with the piston and simultaneously the lever (trigger) for adjusting the feed for the foam gun.

channel RemontDom thanks for the Huskies and subscription. Share in the social. networks - thanks and see you soon!