Flexible vinyl tiles: the best flooring. The process of laying flexible tiles on the floor

Floor covering one chooses for their requirements, preferences. The most common: linoleum, tile, laminate, parquet, etc... Most recently she appeared flexible vinyl tiles.

With it quite pleasant to work (laid easier than laminate). The service life is much higher than the linoleum.

Benefits

Security Health - the main advantage of vinyl tile. It does not emit harmful substances, does not cause allergies. It does not support combustion.

High resistance to abrasion and mechanical the effects (impact). Humidity resistance - another plus tile. Unlike the laminate tile does not become slippery and does not swell when water spilled on it. It can be used for the bathroom.

Even if the lay vinyl tiles under the bright sun, it does not lose color. Clean very easy. The material is light, the tile can put any man.

Vinyl tile is different forms: Square, triangular, rectangular, etc... There is a self-adhesive tiles, with lock, with adhesive tape, tile is on a roll. As there is a tile to be laid using a special. glue.

It should be flexible vinyl tiles as well as a good laminate.

Laying tiles on the floor

During the day, give lie down tiles in the room where it should be laid. The temperature should not be below 15 degrees.

The surface must be prepared in advance. Clear debris from fine dust. The need to maximize smooth floor surface. Concrete floor gruntuem primer deep penetration.

Tiles cut just. On a piece of drywall or plywood, lay tile. We are putting a mark on the line and cut off using a knife stationery. We make an incision in the upper part, and then we add it to fold in half. Then cut through with a knife with the other hand.

Divide the room (floor) on 4 equal parts. Tile laying begins from the middle to the far corner of the door.

You can put vinyl tiles diagonally. To do this you need to additionally draw a diagonal line on the floor. In this case the installation goes on the far wall to the door of the room.

Pre-lay tile is desired without glue and see how things will look. Better to spend time on it, so you enjoy a beautiful and high-quality installation.

Adhesive must be thoroughly mixed. Using a spatula with fine tooth glue is applied. Apply glue do not need immediately on the entire floor. Glue dries in 15 minutes. Therefore, part of the floor to put a thin layer of glue and smooth.

Then attach the tile and press roll to roll on the tile, so that it is well pressed to the floor. Try to roll a good press on the surface of the tile.

From the wall it is important to post gap of 7 mm. The ends between the tiles tightly combined. Tile is laid in a staggered manner.

channel RemontDom thanks readers for subscription and huskies. We wish you a quality renovation!