Restoration of bathtubs with acrylic liquid: a new bath for 3 days

How to upgrade an old bath and make her snow-white, as if she has a new one? Today will tell how to restore the bath liquid acrylic. Since these can handle each.

The term of the bath service life of about 20 years. There is a way to extend this period, transforms it using acrylic. After applying the acrylic to the bath, she does not give way to a new acrylic bath.

No need to dismantle the tiles and do not have to clean the bathtub. We just need to pre-prepare the surface and apply acrylic. How to do it correctly and that the bath served another 20 years, will talk on.

The restoration of the old baths is easy to implement on their own. To begin, you will need drill with sandpaper (Medium-grained - 80). Wear gloves, raspirator as preparatory work (cleaning baths) will be dusty.

Nazhdachkoy through the entire area of ​​the bath in order to remove lime deposits, and other contamination.

Yellow spots on the bath sandpaper may not be fully removed. Therefore, we take special cheap way – Santry with phosphoric acid.

Before working plug in the place where the bath drain. Just pour a bath this tool. On Santry pour loofah and rub the entire surface of the bath.

Bath became noticeably cleaner. Now you need to remove the overflow in the bathroom and clean underneath sandpaper. Good brush to the enamel then stuck without problems.

Next, wash off all the water. Then wipe the bath and remove the siphon. Below move it to the side so as not to interfere with work. The hole also cleanse the sandpaper. Wipe again the surface of the bath.

Take any solvent to degrease, process. Then there is the whole dry bath hairdryer.

Glue around the perimeter of the tile masking tape to avoid contamination of the tiles. At the bottom of the bath lay a newspaper. Acrylic will drip down to the floor may mess. At the bottom, where the siphon substitute a jar to excess acrylic dripped into it.

According to the instructions to mix acrylic hardener. To work it needs the capacity to mix a solution. A solution to flow as a liquid cream. Leave a ready solution for 15 minutes.

Now you need to make a glass from a plastic bottle. Begin to pour the solution on bath sides of the perimeter. With a brush trimming edge. Acrylic will spread and will not smudge on the brush.

Now, fill the bathtub trickle. Acrylic will flow slowly down the drain.

he forms a natural solution discharge level. All defects and cracks acrylic closes. Bath will be snow-white.

It remains to wait until the acrylic is dry (2 to 5 days). Remove the masking tape. Then make the joint between the tiles and bathtub, siphon and secure to use a new bathroom.

channel RemontDom I wish success to be repaired. Subscribe to the channel, will be grateful and huskies.