Modified the screwdriver with a tape measure. Holster is no longer needed

I thought of adding convenience to the instrument, and prompted me to do this, a story that happened before our eyes. A neighbor asked me to pull the clothesline on the second floor loggia counter. But, since I did not have ladders and material for ropes, I made an agreement with the signalmen, they agreed to help her.

As ropes, the guys used a cable with a rope, which was fastened with special clamps using a screwdriver. And since there was nowhere to "stick" him at a height, they held him, then under his armpit, then put in his pocket, in the end he fell, the case broke and the battery flew out. Agree, annoyingly?

Refinement

Of course, it is better to use a holster, I have already done it, those who are interested will follow the link at the end of the article, but it is not always at hand. So I decided transfer the retainer to the belt, from the tape measure to the screwdriver.

He took it off, tried it on on the tool, and smelted the seats for screws with a press washer with an awl heated on fire. Since, for reliability, I planned to drop superglue on the junction, then degreased the gluing places with gasoline. I found small screws, and after scrolling them into the prepared holes,

then he bit off the tips with pliers, leaving a thread slightly larger than the thickness of the plastic of the tool body.

I assembled it, grabbed it with glue, tested it successfully, everything is fine, the part turned out to be compact, and coped with its task. If the guys did this, then their instrument would not break. I have a question, who guessed from the picture and the title, what revision will be made?

Subscribe, share, like, new story soon.
How to make a holster for a screwdriver