He led the socket into the kitchen from the bathroom. Complex case

How to make additional outlet from the existing one I already described it somehow, but here the idea turned out to be more difficult to implement, since the kitchen had to remove the wire from the new line in the bathroom. New wiring with grounding has been laid in the bathroom, so I decided to lead from the outlet there.

In the kitchen, due to new electrical appliances, the load on the network increased, and the wiring remained old. Therefore, an order was received for solving such a problem.

At first drilled a hole from the bathroom into the corridor, exactly through the middle of the baseboard, inside of which it was necessary to lay the wire and start it with a turn around the corner into the kitchen to the desired place. I used a 10 mm drill, it was not thicker at hand, therefore, in order to stretch the wire into the hole, the outer insulation had to be ripped off.

I doubted that a three-core wire of 2.5 squares would normally be passed through the base of the outer corner of the plinth.

The wire is flat, wide and still did not pass through the corner. It was necessary to drill out the base very carefully so as not to break it. Then, I had to push the wire tightly into the cable channel and press it down with a bar from above.

Getting through the corner was probably the most difficult at this stage, but it worked. Then went the laying in the kitchen baseboard with a turn along the inner corner behind the bedside table and the wire exit from the baseboard to the working wall.

Behind the bedside table, a standard one nailed the wall to the tile cable channel 12 mm and released a wire from it onto the working wall at the installation site of the outlet.

I decided to put an outlet not internal, but a consignment note. I mounted it horizontally directly above the tabletop, since the vertical position above the tabletop does not allow simultaneously turning on two plugs with a side wire lead.

In the bathroom, I also had to drill a couple of holes in the tile for the cable channel and hide the wire that goes down and into the wall. In the cover of the internal socket, it was necessary to make a cutout for the wires that entered the socket without insulation.

Good that there was something to drill holes in the tiles in the kitchen and bathroom. I usually use for this German drill that takes metal, glass and porcelain stoneware. It leaves a very smooth edge without crumbling the ceramics.

And so it happened, although at first I wanted to beat the grooves, but stopped in time. I think this is a good option, given that the line in the sanitary block is new. So it is definitely more reliable, especially since it is on a separate machine.

What do you think?

Read other helpful materials andsubscribeper channel.

Wallpaper for 5000 rubles per roll. For what?

Unusual decoration of walls and slopes. You can try it yourself

What fittings for the tank are not worth buying