"How I fixed the car with a pet bottle" - Eliminated backstage backlash
There were three problems that I decided to fix myself, the handle did not open from the inside, from the driver's side, the seat was not regulated there. I did it, especially with the chair it turned out interestingly, but more on that another time.
Eliminating backlash with a pet bottle
The time has come to remove the backlash backstage, an ambush awaited during parsing, among other things, its stops broke off.
On good, it would be necessary to replace, it seems even, somewhere there is a Chinese analogue, but I decided to do it on the spot.
I cleaned the part with a solvent, decided to glue it on superglue with soda.
Repeating over and over again glue, soda, glue, formed a cone, increased it thicker, it turned out tightly, it’s turn to paint the ball.
I cut off the bottle by 0.5 near the neck, put it on, and began to push it with a hairdryer.
I cut off the excess, missed the ball and the seat, entered with an interference fit, the backlash disappeared.
I made a retaining ring out of wire, installed it, the fit became even tighter, the speeds switch clearly.
I found information on the Internet, there is also suggested to use heat shrinkage instead of plastic, but this is not serious, the pet is much stronger. I did not expect that the bottle and the car can be repaired. In general, my first steps as a car enthusiast continue.