I remembered how to twist the wire, it came in handy for ventilation. One "adapted" helped

I attach the ventilation pipe to the stretch marks

The gasmen ordered the hostess to install ventilation, contracted to do it. It seems simple, but the nuances (a hole in a ceramic tile, insulation of a pipe), which I will tell you about next time, have been brought up.

Wire twisting

I came up with this method when I was working on the installation of communication lines. When servicing VLAN we got by with two pliers, but there were no such volumes.

3mm plate with holes

The bottom line is simple, in a strong metal plate, you need to drill holes through which the tip of the wire should pass. You do the first turn by hand, then you put on the device and twist it.

If the wire is not taut, hold it with pliers, and when tensioned, a plate is enough. It is very convenient, especially when you need to make a lot of twists, and even more so at a height. The tip is trimmed and compressed.

British connection

So we called this splicing in connection, for example, we twisted one end with pliers, and the other “fit”.

The result is the same, but if you need to make a "bunch" of such connections, then you appreciate the convenience of the device, especially if the wire is stiff. I hope this is useful to some of the readers.