How to make the crown of the tree is not smoked. Useful trick.
When dealing with wood and building materials based on it quite often there is a need to make them round holes.
not infrequently for this purpose special drill is used - crown.
And everything is goodonly often drilling crown (Especially low-cost) tree It starts smoking.
The reason for this phenomenon is very simple.
SawdustFormed during drilling, clog teethcrown because of what increases friction and generates heat.
As a result, chips begin to smoke.
To avoid this, you can useone simple but useful trick. What? Consider the following.
Begin the process of drilling a hole in wood you need a road marking. To refer to the center better not to use a pencil and awl.
After that, you need to Drill crown to a depthnot more than 5 mm.
To drilling holes sawdust did not smoke, they must be removed from the kerf.
You can, of course, their periodically shake and again to continue the drilling process.
And it is possible to apply a simple and useful trick.
It is what you need in a place to make drilling a through hole using a drill diameter of 10 mm.
It should be located the inner side of the intended range on the border of the kerf.
This hole will serve as chip evacuation.
Through him sawdustFormed during drilling, will be removed from the cutting location.