How to easily install the floor plinth with his hands.

Room after edging skirting becomes harmonious and finished look. But this is not its only function. Plinth as to hide the wires and the gap between the wall and the floor.

In general, the process of installation plinth is fairly simple, so it is quite possible to perform with his own hands.

But, without the knowledge of the characteristics and installation of technology, of course, can not do. On them will be discussed below.

Installing plinth must begin with the corner of the room, pre-clearing the floor from dust and dirt.

And so, for a start, with plinth remove the lid of the cable channel, are attached to the inner corner of it and apply to the corner.

Usually to secure the plinth to the wall separately drilled holes in the wall and in the plinth for fixing. Dowels thus clog directly into the wall.

But the installation process can be easily simplified by making one hole for mounting directly into the baseboard and the wall.

Technology is as follows:

Skirting is firmly pressed against the wall and the floor. With the perforator drill holes at intervals of 45-50 cm.

Then we hammer anchors, fasten screws and install cable channel cover into place. Skirting interconnected via connectors.

That's so easy and simple it is to install baseboards around the perimeter of the room with his hands.