How to easily install transoms with their hands.
After completing the installation of interior doors often it turns enough so that the width of the door frame does not cover the entire width of the doorway and on the mind is part of the wall finishing.
You can, of course, this site is plastered, pasted wall-paper, but the easiest way to revet wide opening via transoms.
In addition, it can be done simply by hand. How? Consider the following.
We begin the installation process with transoms removal sizes. To do this, apply the level of the wall, and the square in the slot on the door frame (where transoms will go) and measure the width.
Then transfer the markings to final assembly of the board, the masking tape is pasted previously.
And using a jigsaw saw off the desired width of the transoms.
Set Finishing panels into place by aligning the plane of the wall, fix the screws to the box and zapenivaem with foam.
As well, it is imperative to fix with masking tape transoms to the wall to avoid being squeezed foam.
After drying, the foam can proceed to the assembly casings.