Useful tips to help you make the right cut corners with their hands ceiling moldings.

Because as far as the correct cutting angle made ceiling moldings it depends largely on the aesthetic appearance of the overall finish.

Therefore, at this stage of the work during the installation baseboards need special attention.

Helpful tips below are just to help in this.

Tip number 1. Training - the key to success.

Get a flat angle cutting ceiling moldings, if you do it the first time, it is very difficult.

In order not to spoil the plinth is advisable to first practice on unnecessary small pieces.

Tip number 2. Cutting must be done with a sharp knife on the solid surface.

Ceiling plinth made from foam, easily crumbled and pressed. Therefore, it is necessary to cut it with a sharp knife just by placing a plinth on a hard surface.

№3 Council. Small defects can be corrected.

Malfunctioning docking plinth elements can be corrected office knife during the cutting process.

And if, after installation in the corner to get a small gap, it is possible to mask using putty.

№4 Council. Need pre-fitting without glue.

Before applying the glue on the ceiling moldings need to make a preliminary fitting. Only after docking angle was successful, you can proceed to further installation.

I hope these simple tips will be useful to you when cutting corners with their hands ceiling moldings.