How to make a smooth and square corners when plastering walls with his own hands.

Jagged angles can negate all the efforts of the attached during repairs and eventually finishing will look messy. Therefore, the angles of the alignment process, it is crucial final stage of the walls, which should not be neglected.

Make the corners smooth and straight with plaster walls is quite possible to their own hands. How? Consider the following.

Most often alignment angles perforated corners used in the plaster. They allow not only to achieve a smooth, right angle, but also protect it from mechanical influences.

The process starting with the alignment angle of the surface preparation (cleaning and priming).

Then we do the measurements and using scissors metal cut off the desired length of the perforated corner.

Knead rotgipsa solution with a spatula and apply a small "cakes" on the edges of the angle interval 25 to 30 cm.

Is then applied on top of the "cakes" rotgipsa perforated angle. With the rules and the level of tightly pressed to his corner.

Excess rotgipsa, samples through the perforations, clean with a spatula.

Then we look forward to when the plaster dries and fix the perforated angle.

Then we coat solution rotgipsa empty space remaining at the corner, and align the abutment surface.

In conclusion, it must be said that the above alignment method suitable for corners with a small difference.