Useful content

Winter is on the threshold of how to preserve the pool

click fraud protection

Winter - the most difficult time for the owner of the outdoor pool

Summer in the beautiful plescheshsya some water, lie on the rug and do not even think about that very soon all over. But the winter, while the frost is thawing, the snow will be very long. And it can destroy your favorite pool, which has been invested so much effort and money. But this, of course, will not happen if you do it right.

Users of our portal Glaubend - in confusion: its pool depth of 1.5 meters is recessed into the ground by 90 centimeters. Water should be left how much? How many five-liter bottles to throw it, and how deep they are immersed? And whether it is necessary to make a small hole on top for air bleeding at the time of squeezing the bottle with ice?

Most importantly, say experienced forum users - this time to preserve the pool until the first frosts have burst. At the same time, rather than later you will can a swimming pool, so it will be less scrub spring. So it is necessary to contrive, and to find the right moment!

instagram viewer

In no case do not leave for the winter empty pool. The fact that the soil in which your pool recessed, winter changes in volume. In cold weather it is frozen, thaw in - thaws and can break even concrete pool wall, not to mention the submerged karkasnike. Unfortunately, this was the sad experience of the portal for many users.

A frozen water inside the pool partly compensates for these loads.

Sernik

Member FORUMHOUSE

According to the technology, all the outdoor pools have to fill with water in the winter. With conservation, reopening a lot of trouble. Autumn - drain, plug all openings to the pipes was no water flood back. Distribute garlands baklazhek waterlogged, and it will break the ice pool. How not to chlorinating water in winter, spring pool - zatsvetshy completely, scrub torment. And the long wait for the ice melts, swim in April, it would be desirable ...

To trouble was a little smaller, many forum users do not bother and frozen in winter the water in which swim all summer. Some experts say that it is wrong that the summer water should be completely drained, rinsed well and the bottom of the pool wall, then fill it with fresh water, and then - to merge to the desired level. Consultant in our forum Besrom He considers that it is sufficient to carry out a shock chlorination, and then the pool water "drained below the suction and supply lines."

In general, each pool conserved in different ways, depending on the filtering system and on the material of construction. But the basic layout is always about this:

• The water is drained before re-Gulf water carefully cleaned the bottom and sides of the pool. Filled with new water. Blends (for 10 cm below the side nozzles).
• Pipelines dried and purged with compressed air.
• Understand filtration systems, disinfection, attractions. Of these systems, the water is drained. From the filter sand is poured.
• In all mortgages elements - jets, spotlights, skimmer - installed plugs.
• Set the volume expansion of water lifters (members of the forum experience has shown that this task is best to manage five-liter plastic containers).
• Water Mirror covered winter shelter for the swimming pool.

real310

Member FORUMHOUSE

I read that the cans can be filled with sand lightly. But it seems to me that this is - not the best idea, because the water, squeezing the bottle, can damage the stopper, and then sand vysypletsya into the water, where it will be difficult to collect the following year. Snap to the stones? I do not have the stones and concrete blocks, I'm afraid, hurt the film (I karkasnik).

Plastic containers, which may well shrink with increasing external pressure, probably the best compensators. At the forum they are almost all owners of swimming pools. They should be filled with air, and for better submerged to the bottles attached loads. Another forum users use slightly inflated tires or blocks of foam plastic, which is also tied loads: usually sandbags.

Forum, whose pools have survived several winters, say plastic containers are best filled with sand by a third: and the air is enough, and the canister is enough to go deep into the water. The fact that the sand is poured into the water, no one has yet complained. The bottles are not collected in one place, they are tied to the sides of the pool.

The best option, experts say this: in the center of the pool pritopleny plastic containers, and next to flanges at a distance of 5-10 centimeters, foam plate has about five centimeters thick. The foam is distributed evenly, and its total length should be not less than half of the perimeter of the pool.

As will bind loads (e.g., sandbags), do not use metal wire. Take a strong cord made of synthetic material.

The next step - disassembly countercurrent apparatus filtration unit, heating system, etc.. Anything that can not be removed and carried out on the storage premises shall be exempt from water. The free ends of the tubes are closed with plugs. To shut-off valve does not burst from the expansion of the frozen water in it, the handle should be left in a position at 45 degrees with respect to the pipe.

The filter is detached, water is drained out of it, pour sand. Sand dried (shag12 also sifts) and store in some capacity or linen bag.

Some forum users too lazy to bother with sand and as a filter stored in a dry unheated basement, leave it in the filter. And even the "head" of the filter does not remove everything. It's against the rules, but many are no problems because of this does not occur.

Andre.voda

Member FORUMHOUSE

I am from your filter head is not removed and the sand does not spill. Just drain the water and put the handle on the head in position OPEN.

"Whatever you do, you do at your own risk" - say in such cases on the forum.

The easiest way to prepare for the owners of the winter collapsible swimming pools, which are kept indoors. They poured water, soft bristle brush wash the walls and bottom are treated pool inside agent from algae, thoroughly dried sides and bottom fold and strictly according to the instructions, wiping dry the ground adjacent to the bottom portion as folding. means processing of algae helps to avoid the smell of rottenness.

pool reactivation begin only when the ice melts in the pool himself. In any case it is impossible to peck his improvised means. This can result in damage to the bowl pool.

Swimming pool - expensive and very nice thing to be sorry if she did not survive the long winter. Use the experience of the venerable members of the forum users here they answer questions beginners. And so in the summer with the reservoirs had no problems, learn, how to protect them from flowering. To have something to protect, read, how to build a beautiful stone pond.

IN video - on a garden site with a unique hydraulic system of two ponds and a creek.

Subscribe to the channel. Share in social networks. Join FORUMHOUSE!

Both without expensive Tiretov I remove the blockage in the sink

Both without expensive Tiretov I remove the blockage in the sink

photo illustration taken from open sourcesBlockages happen very often. I think that it is not onl...

Read More

Always with you: Mobile bath

Always with you: Mobile bath

What are mobile baths, views and personal experiences of the participants of the portalBath - a w...

Read More

Warming of a private home. We are looking for a universal heater.

Warming of a private home. We are looking for a universal heater.

Threads with the selection and description of the features of a particular type of insulation are...

Read More

Instagram story viewer