What should I do if the plug falls out of the wall

So pulling the power cord, for example, a vacuum cleaner, you see very unpleasant picture: your plug pulled out of the wall, together with a fork. It is necessary to urgently correct this, and how to do it correctly and how to further use the socket to avoid this, I'll discuss in this article.

repair options

Important. Before embarking on any action necessary to protect the workplace. To do this, go to the switchboard and disable the machine that feeds the rosette line. If it's not, then simply disable the opening gun.

So, let's first examine the classic version, when the socket fell out of concrete (brick) walls.

The first thing you need to understand the reason why there was an unpleasant event (can get rid of minor repairs).

The most simple and harmless cause may be an ordinary attenuation screws that when tightened the clamping foot bursting.

And it will be just enough to tighten them well and the problem is resolved.

But if it's not loose screws, then let's move on. So, look carefully podrozetnik if it is made of metal, the spacer legs can not long hold the seat (especially with the active use of it), so this podrozetnik have to replace a new one from plastic.

To do this, remove the old (metal) Escutcheon. If necessary via hole to increase the crown new Escutcheon (bearing seat must be greater Escutcheon diameter 5 mm).

Then carefully remove dust and damp hole water.

Further handle niche prepared solution of gypsum and also inflict little solution (gypsum) on the back side Escutcheon.

Then thread the wire into a new podrozetnik and paste it into a prepared niche. For better density gently tamp it with a hammer and set flush with the wall.

Then give alabaster (gypsum) is completely dry and can install the outlet.

For greater reliability, secure it in the seat not only by the lugs, but also with the help of the mounting screws on the Enclosures.

All are now close decorative strip and use the socket.

It can also happen that you, and not at all Escutcheon. In this case the sequence of actions is the same as described above.

Important. If the standard is not included in podrozetnik niche and deepen it there is no way it is not necessary to cut off the bottom of the Escutcheon, it is better to buy a special shortened podrozetnik. Thus, you save it rigidity and fixation outlet is reliable.

Well, like with concrete (brick) walls clear. Now let's look at a situation where the socket falls out of drywall.

Drywall

If you happen to such a situation that the socket fell out of plasterboard with a piece of plaster, then proceed as described above will not work. And all because Enclosures Drywall attached a slightly different way: here in the presser foot is used as fasteners.

To rectify this situation must first regain Plasterboard coating returned back piece gypsum board using plaster or filler. After solidification small strip cut from a sheet of plasterboard, place it under the damaged place and fix with screws.

An alternative embodiment of the output of such a situation is that also fasten the plasterboard into place fallen off. Then, in a circle of holes cram crumpled paper and fill it with dense gypsum putty. Then dent Escutcheon until it snaps flush with the wall. And wait for the complete drying of the solution, and then set the socket back into place.

How to prevent breakage

The main reason for loss of their outlets seats - is improper use. Often, instead of gently pull the plug out of the socket holding a fork in one hand and the other holding the outlet, we just pull out the plug of the power cord.

If you wean yourself from this bad habit, you will have much less to repair their sockets.

That's all I wanted to tell you about what to do if plug fell out and how to fix it. If the article was useful to you, you will appreciate it Like. Thank you for your attention!