Useful content

Steps in installing washbasins and what you should pay particular attention

click fraud protection

For proper installation of sinks is necessary to observe the following steps:


1. Performing measurements. The place where you plan to put the sink need to fathom a tape measure to determine the dimensions of the sink. This priority and a prerequisite is performed in order to keep it so happened that when the purchase and the subsequent installation of a wash basin did not fit in size and not in place of it in the allotted a place.


2. Search and acquisition of the appropriate instance. Favorite model is necessary as well to fathom, to match the size of the installation site. Socket sizes sink can buy with delivery to the installation site.


3. Acquisition of associated elements. washbasin fixture. Typically, hardware comes complete with a washbasin. This time be sure to check back in the store. If fixing is not complete, it must be purchased separately. These are two dowel - pins with special washers and nuts.

Just once to buy a mixer, lead-in sleeve (hoses) with corresponding attachment and siphon kit.

instagram viewer



4. Setting to the desired location. Washbasin with counter, in this case, a bedside table, put to the wall. Inside the ceramic washbasins are holes for attaching it to the wall. In pencil or marker shows fixing points on the wall.

Washbasin set aside, and by said tags corresponding threaded holes drilled stud. It is important to determine the height of the drill holes, so to be able to sink the height adjustment.

If you do not, you can not sink adjustable slope toward the wall, and it will collect the water, which should not be there. Therefore, when the preliminary measurements and elevations for drilling be sure to use a level.

Washbasin at the same time is set at a slight angle to the horizontal imperceptible order. That water does not accumulate around the mixer and blended.


5. Before sink is fixed, it is necessary to install a mixer, to which immediately screwed sleeve for supplying hot and cold water.

After that, wash basin set in place and firmly secured to the wall with the help of pins. Next, a siphon and is connected to the sewer pipe. Siphon installed, and the sleeve can be screwed to the mains hot and cold water. Checking for the presence of the water supply and sealing installation.

p.s .:My HouseHe is trying to give you the most important, useful information. If you liked the article, please put "like".subscribe to the channel - in front of a lot of useful and interesting information!

Chokeberry, benefits and recipes.

Chokeberry, benefits and recipes.

Somehow chernoplodki not popular among farmers, but it's in vain. Chokeberry - a plant that does...

Read More

Entry group to fame: DIY Gates

Entry group to fame: DIY Gates

Fotoinstruktsiya on the construction of the entrance to the site with a group sewing the gate and...

Read More

What not to do in the fall

What not to do in the fall

Gradually, the season horticultural works like the end, which means that it's time to prepare lan...

Read More

Instagram story viewer