Options shtrobleniya walls under the wiring in the house

Until now, one of the most reliable ways to hide the wiring in the walls is just shtroblenie. In this article we will look at all the existing types of shtorbleniya and examine their strengths and weaknesses.

How to perform shtroblenie

Even this seemingly simple job has quite a number of rules that will be sure to:

1. Stroebe need to perform only in the horizontal and vertical planes. Option "obliquely" unacceptable.

2. Grooves laid under the ceiling in the region of 15 to 40 cm from it.

3. From the corners of walls, window and door openings, as well it should be a minimum distance of 10 centimeters.

4. From the gas pipe indentation should be at least 0.4 meters.

5. It is strictly forbidden to lay Stroebe in bearing walls, beams and columns.

preliminaries

Begin to shtroblenie need after the project will be prepared, which will be applied to all the tracks with switches and PDUs.

Since this process is quite noisy and dusty, be sure to prepare masks, wet cloth curtain the passages in adjacent rooms and take special headphones. Also, if ceilings are high enough, then take care of the presence of scaffolding. Remember that with ladders and stepladders to operate the power is prohibited.

Also, be sure to make sure that the walls did not remain the old wiring energized.

shtroblenie puncher

Shtrobleniya This type is most widely used in everyday life. And we realize it is very simple: to start the note with the help of the construction of a pencil or marker track, then nasverlivayutsya holes across the line at a distance of about 1 cm, and then a perforator blade nozzle in the form performed groove.

pros

- during the operation produced little dust

Minuses

- loud and rather long process

- Stroebe get sloppy.

shtroblenie grinder

Perhaps this is the second of the most popular ways to perform cutting grooves in the walls. Again, after being marked trail takes Bulgarian and using it to make two parallel cuts. Then drill is taken with a special nozzle and the concrete is cleaned out of the groove.

In this case, it is desirable to use an industrial vacuum cleaner, as in the process of sawing formed a huge amount of dust and should be promptly clean up. The algorithm works as follows: one wall saws, and the second (helper) with a vacuum cleaner removes dust.

pros

- Neat Stroebe.

- Work is done quickly.

Minuses

- a large amount of dust, which need to be removed with a vacuum cleaner.

- For sawing walls need to use quite expensive diamond blade.

shtroblenie Wall Chasers

This option is not in high demand, as this equipment is expensive. Wall Chasers have just installed a pair of diamond disc, which he makes cuts at the same time, the width and depth of cut, you can easily adjust. There also remained in Stroebe material is removed using a punch.

pros

- just perfect Stroebe

- a minimum of dust using an industrial vacuum cleaner with a wall chaser.

- depth and width selection Stroebe.

- the quickest type of work.

Minuses

- The most expensive way possible.

Shtroblenie hammer and chisel

This method is used when there is absolutely no tools.

pros

- you do not need electricity

Minuses

- spend a lot of unrealistic time and effort.

- Flatness Stroebe is far from ideal.

- For RC walls you do not do anything.

That's all the basic ways of cutting grooves in the walls of the gasket. Which to choose - you decide.

Thanks for attention!