How to make a night light out of the box for CDs and LED strip
Now, going to the store, you can find almost any product to the most exacting taste. But until now, handmade gift or decor elements, is rated higher purchased options. In this article I'll show you how you can make very creative portable lamp of a small piece LED strip, crown and an empty box from under the disc.
the necessary equipment
So, for the successful implementation of the lamp, we need:
1. Box for CDs and a few unwanted CDs.
2. Diode tape on 12 volts and the battery (I chose the crown).
3. Gun with hot glue (you can do the usual super glue) and a knife.
4. Soldering iron with solder and a small piece of flexible wire (from which we need to remove the individual wires).
Getting to the assembly fixture
So, first of all we take our LED strip and to cut it into three strips of each of the three diode (tape should be cut severely in places designed for this purpose).
Then, if you do not tape with self-adhesive surface, then we take the gun with glue, put on a CD glue and attach the previously cut strips as follows:
So now we need to link our band divided again into a single network. To purify this by insulation flexible wire previously prepared, and individual veins join the tape strictly correct polarity
After that, you and I need to check whether our band works, for this we take our crown and also in the correct orientation leans supply wiring to the minus and plus diode tape:
So, everything is working now take the disc with tape stuck with glue and fasten it to our box for a disc on which the pre-clipped the plastic pin on the aforesaid worn discs.
Then, in the center of the drive is attached to you our crown.
So now you and I have to worry about enabling and disabling of our lamp. To do this in a transparent housing bore holes under the selected switch.
Then fasten the top as the glue still drive like this:
And after that we fix it there so that the outside appeared a changeover lever.
Then connect therethrough circuit switching and check on the performance.
All creative and I must say a very pretty lamp is ready. If you liked this article, you will appreciate it Like.
Thanks for attention!