Installation Instructions Escutcheon in concrete, drywall and wood

In the majority of cases podrozetnik has a plastic version, set in the aforesaid outlet or circuit breaker for indoor installation. By - large Escutcheon installation process is simple and extremely should not cause any difficulties, but Depending on the material of your walls: concrete, brick, wood or plasterboard, there are small nuances of the competent installation. That's about it I want to tell you in detail.

Choosing the right podrozetnik

Before you begin to install the product, you need to select and purchase. To date, the shelves of specialty stores, you can find the following modifications:

1. Plastic, without any special pressure plates. Designed for installation in concrete and masonry walls:

2. Still plastic, but with pressure plates. Used for installation in plasterboard and plastic panels:

3. Metal, with the back cover and without it. Previously were widely used in homes panel type, but now apply only in wooden houses and then, if you decide to perform internal wiring:

So, you have decided on what type you need and have acquired the required number of pieces. Now we need to prepare the inventory.

Cooking tools

To successfully tie, we will need:

- Punch or drill.

- Specialized bit on that type of surface, where we will set the Escutcheon. If not, then prepare Drills (concrete or brick).

- Level and marker.

- Alabaster, putty and a putty knife (not needed if you have a wood or plaster).

- a hammer, a chisel and chisel.

That's all we could need for a successful installation.

We begin the installation

Set in concrete or brick

You have concrete or brick wall, then use the following sequence of actions:

1. On the wall mark with a marker center and the outer radius Escutcheon in the place where your future will be socket, according to pre-made plan. And choose a comfortable height for you, since according to the technical documentation, the height of sockets selected location extremely comfortable in your specific case.

2. Then, using a crown drill a hole to a depth of greater than your glass a few millimeters. In the absence of crowns just drilled holes along the contour traced a circle, and then using a hammer and chisel remove excess concrete or brick.

3. Then insert Escutcheon and check that it "sits" in the slot properly, thus immediately cut a hole in it and slide the cable.

4. Then prepare Alabaster, then treat with a solution of the installation location and put Escutcheon so that the fixing screws have been strictly in a horizontal plane. This is very important if you have a socket strip and if you put podrozetnik curve, the end result is a curve socket strip. What really spoil the appearance.

All Escutcheon installation in concrete or brick can be considered successfully ended.

Mount in drywall

Fix the "glass" is much easier to cast. There is no need to work actively with a chisel and hammer. Suffice it still mark the mounting location and drill a niche with a special crown.

Then insert a special glass with a mounting plate and fix it in position.

That's all for this.

Installation tree

If you do decide to perform a concealed wiring in the tree, in this case, you need to still use the bit of wood and a chisel to extract the excess wood.

That's all I wanted to tell you about the installation Escutcheon in different types of walls. I hope the article has been helpful to you. Thanks for attention.

Dear Reader, my article was useful and interesting?! Then be sure to Put thumbs up, subscribe to my RSS feed ENERGOFIKSIK and share articles to social services. networks. It is very important to feel your support. After all, it will create even more high-quality materials. If you have any questions or suggestions, here is my email: [email protected]