How to find a wire hidden in the wall of the options considered by the working

In order to find where in the wall you pass the wire feed, for example, your outlet, not necessarily immediately call an electrician with special equipment. It is possible to do on their own. But how do I explain below.

What we are looking at all the wiring

There are several reasons for that are usually looking for hidden wiring:

Re-planning room. You started a repair and, for example, you need to do a new window opening.

Faulty wiring. You have the most unpleasant thing happened - a short circuit. And you just need to look for, where there is a wiring to eliminate the defect.

The need for any equipment installation. Let's say you want to hang a shelf. And so during the drilling they did not break the wire, you need to know where it goes.

Curiosity. You bought a new house or apartment and you want to know how to construct the mains.

modern methods

Now modern devices can be easily purchased at any major electronics store. Therefore, if you are not particularly low on finances, you can purchase one of these devices for personal use.

The best at this moment is the E-121 device or "Woodpecker." This instrument clearly demonstrates where the wire passes and even specify the place where there is damage to the wire insulation. Moreover, the device can do it at a depth of up to 7 cm.

Here is a list of devices, these should intended for finding hidden wiring: POSP-1, GVT-92, BoschDMF 10 zoom? GVD-504A, VP-440.

I will not consider in detail each of the devices, since the principle of their operation is the same, and the use is extremely simple.

Now let's look at a more affordable ways that do not require financial investments.

ratiocinate

Anyone, even a novice electrician should follow the generally accepted rules, and there in black and white that all the wires are laid only on the horizontal and vertical lines. In this case, the floor and ceiling of indent should be at least 15 centimeters.

So if you see a socket, it means above it is not necessary to drill any holes to hang, for example, a shelf.

Important. Unfortunately, not all the master strictly follow this rule, so for 100% certainty must also check for wiring in another way.

father's methods

Modern instruments - is not a panacea, because with you our fathers and grandfathers easily coped without them. So let us remember, as they did.

we usually tear away the wallpaper in the case of major repairs. And here, to be careful, we can see that Stroebe, the add stacked wire, usually embedded solution, the color is slightly different (because to do the same batches unrealistic).

Take the simplest receiver and set it to 100 kHz and drive them up the wall. At the same time near the wires, these should be under stress, you will hear the noise amplification.

If you have a microphone, then proceed as follows: turn on and drive it on the wall, where there was noise from the speakers, our wire is hidden.

Important. These methods are not endowed with great accuracy and can make the run to 20 centimeters.

That's all I wanted to tell you how to find our hidden wiring in the wall. Thanks for attention.

Dear Reader, my article was useful and interesting?! Then be sure to Put thumbs up, subscribe to my RSS feed ENERGOFIKSIK and share articles to social services. networks. It is very important to feel your support. After all, it will create even more high-quality materials. If you have any questions or suggestions, here is my email: [email protected]