How to weld rigid and flexible wires

This type of installation is not desirable to use the course, but if there is such a need, in this article, we will elaborate on the correct sequence of actions, which will perform a qualitative compound.

Say at once soldered aluminum and copper is impossible, so we will consider soldering a copper-copper.

The correct sequence of actions if sufficient slack in the wiring:

The first thing we clean the wire, if resources allow, then both ends make the removal of insulation to a depth of 5 cm;

Then we clean hard wire required with a knife or sandpaper;

Next we need to perform a twisting of the flexible and rigid wires. To this end, the flexible conductor is wound around the hard way that one core was wrapped about the middle. Then hard wire bends in half and with a pair of pliers prozhimaem. You should get a connection here:

Now we are preparing a soldering iron, rosin and tin;

Once warmed up soldering, process twist in our rosin, and then put on her tin;

All our solder twisting ready, now it remains insulated with electrical tape, and can be operated.

The algorithm, if the stock is limited by wires

In the case, when we have a small stock of wires, then perform pre-twist can not be done. From this situation, too, is a completely reliable and secure solution.

The first thing we all also clears away the insulation on both conductors, but the 2 cm (you can of course more, but impractical to do so).

The next step and use a knife to handle core

Then take the heated soldering iron and peeled tinned ends (flexible pre further twisting the wire).

Then the tin-plated wire leaning against each other and propaivaem them using a soldering iron, you should have such a connection here.

All of our soldering is successful, and now just isolate this place with electrical tape, and our guide is ready for active service.

Dear Reader, my article was useful and interesting?! Then be sure to Put thumbs up, subscribe to my RSS feed ENERGOFIKSIK and share articles to social services. networks. It is very important to feel your support. After all, it will create even more high-quality materials. If you have any questions or suggestions, here is my email: [email protected]