I decided to install in the bathroom shower
Decided to install in the bathroom shower. Firstly, for a small bathroom is the best option, and secondly, it is more convenient to look for.
Getting started with the dismantling of the bathroom.
dismantling
For this, I disconnected the sewer hose, turning the bath, took off the legs, and then passed it.
installation
To install a cab in the first place, I chose a place in the bathroom. Decided to install a cabin near the hoods to ventilation was carried out in the cockpit!
Adjusting screws, which are located at the bottom of the pallet cab for "level" (an instrument for measuring the surface flatness) exhibited pallet.
Fastening screws, screwed to the pallet base cab, and then the upper part. All connections are closed up with silicone.
After that, I proceeded to install movable doors. Before work, I lowered the door rollers in liquid grease so that the grease in the bearings stiff. I do this because in the booth will be high humidity, and the bearings may rust and become defective.
After removing the excess grease from the rollers, attached them to the door of the moving and fixed in the grooves.
Adjusting screws on the rollers and adjust the movable door. I bought a cabin with sliding doors because they are set is not simple gaskets and magnetic, and while the tape themselves choosing between the door gap.
supply sewerage
At the bottom of the tray has a hole into which I put in a siphon, and started the corrugation in the sewer network.
Connection to the mains
Connection to the mains, performed using a flexible black hose. They are used to connect gas cookers, because the heat-resistant.
White hoses to put not recommend it, especially for hot water! Their blows, and they become useless. I use flexible hoses to the cabin, if necessary, you can move away from the wall and clean the siphon.
At the edges of the hoses are moving nuts with spacers.
These nuts, I clocked up on the joystick, not much pressing, so as not to crush the gasket. The other end of the hoses connected to the pipeline in the same way. Between line and hose, set the shut-off valve.
The installation bath cabin came to an end. The whole family was pleased!
On that channel everyone can share its experience in the construction, repair and improvement of your home, suburban area, send photos, tell me about your country, house, apartment. And we will tell you about my little house on the canal. Information and photos (preferably horizontal) send to [email protected]
Subscribe to channel MY HOUSE - in front of a lot of new and interesting information!