As the two heroic "novokubantsa" build his "dream house" (do interior walls)

I continue the story of how two heroic "novokubantsa" build his "dream house" in Krasnodar. Only now our house is geographically located in the city, in fact located in a farmstead on the outskirts of the metropolis. Of course, we are deprived of some of the benefits of civilization, but we have one distinct advantage - the rural peace and the birds singing in the morning. On summer nights we have often filled nightingale hidden in the branches of trees. This never hear in the realm of the concrete. And to this is added the indescribable beauty of our gardens, which give not only aesthetically pleasing, but the food is tasty apples, apricots, and other wonderful fruits and berries.

Today I want to share a story about how we were doing interior walls. Interior walls in the house are made of aerocrete, size 15 * 25 * 60 cm. We discussed the material for the partition from the beginning of construction.

I had the idea to do it from the drywall. This material is somewhat easier to work with partitions, when working with them does not deliver a lot of dirt. Another advantage is the mobility of drywall. Ten years from now, if you want, you can completely change the layout of the house, dismantling the gypsum frame (though on a few people dare).

That's only significant drawback is the low frame soundproofing. Many are ready for it, we can not. Our walls are stronger, more reliable and coping well with the preservation of peace in the room.

our home project has already begun to change. Previously, access to the garden was planned from the back of the house, only one bedroom was located on the ground floor. Now output has moved to the side, in its place there is another bedroom. They became two on the first floor. But by building a full second floor, my husband has not yet been refused. Just decided to finish his postponed indefinitely. For this and needed extra room.

The first series of walls laid out on a cement slurry, because concrete slab (it subfloor) does not differ ideal evenness.

During the construction of the main walls are supposed to do "mortgage" (editions of the wall reinforcement, brick or block) for the subsequent laying of interior partitions. As always, it was not our case. The walls of our room were born in our minds in the course of construction, so there is no mortgage, we could not do. We use a simple method of fitting the unit to the main wall with screws.

Screws take long - 12 cm, in order to mount was the most reliable. Screws we bought yellow. They are less prone to rust. Thus, the husband is attached to each series of aerocrete main wall. How many packs of screws gone - I do not remember, but certainly not one and not two.

The second and subsequent rows husband already spread on a special adhesive. This brand of glue we used for the first time. Produce it in Rostov. We took it on the recommendation of the manufacturer's units. He said that the adhesive composition of high-quality reinforcement. I can not say for sure about the reinforcement, but the quality we have no complaints. Clay is good, you can take.

Despite the fact that we used reinforced with glue, the walls had to be additionally reinforced. Glue was little hope. On the internal partitions we used for the reinforcement of the walls of masonry grid. This grid we laid the first row, and then do the operation on every third row. Photos here but I did not.

Jumper over doorways poured concrete. For this block sawed lengthwise and installed it on both sides. The board was established as a support. This board has served as the bottom of the formwork. In laying concrete reinforcement 10 mm in diameter.

So gradually we have put all the internal walls on the ground floor.

On that channel everyone can share its experience in the construction, repair and improvement of your home, suburban area, send photos, tell me about your country, house, apartment. And we will tell you about my little house on the canal. Information and photos (preferably horizontal) send to [email protected]

Subscribe to the channel - in front of a lot of new and interesting information!