Transfiguration dull bathroom into a neat bathroom. Economical repair. PVC panels: the installation of the walls and ceiling.

Bathroom renovation is in the final stage. After the wall and the ceiling, I connected the LED lights to the network and enjoy the results of this work. But to be able to celebrate this deal, it remains to bath, to collect for her apron from the wall panels, and close the box frame.

One of the most challenging and important parts of the installation it was bath: as the bathroom was quite small quadrature, had to organize dancing with tambourines and involve assistant. In the course of this work, I have often thought that knowingly bought a cast-iron bath instead of steel.

Remove all excess from the bathroom, I pulled a bath and stuck to her foot already out there, otherwise it would simply not slipped through the door. First, not without difficulty, we have launched it with the assistant 90 degrees, that is parallel to the installation site. Then, lifting and placing it on the edge of the apron beam feet up, turned to the desired position and is very careful not to damage the panels on the walls, put on the floor. To assess the accuracy of the process, the jewelry will add that the gap between the tub and walls as a result did not exceed 3 mm on each side.

Fixing bath to the floor with dowels and screws, I started the installation box. Its upper part is made of a single integral panel, in which the holes were made under inspection hatch for toilet (For access to the common tap water blocking and counter) and two circular holes for the input and output communications washing cars. Panel insert in grooves provided in advance profiles - inner corners, on the other hand, the corresponding edge of the box, has been installed outside corner.

The vertical part of the duct is made of scraps of wall panels, with the remaining skin of the wall above it. There were openings are provided beneath the bowl and one corrugated plastic lattice provided for ventilation (prevention debate inside the box) and access to the compounds of the tubes. When setting profile used in the form of an internal angle vertically and already existing outer corner at the top. Bottom wall left without a profile, as you plan to install baseboards throughout the remainder of the toilet area.

The most difficult part of the assembly turned out to combine different profile in the places of their joints, specifically the right border of the box and skirt, there has been a connection between two inner corners and one outer. After several attempts I managed it, the result is not ideal, but it is quite adorable.

Finally, apron bath paneling betrayed final touch repair. With this part of the special difficulties have arisen, since most of the items had already been provided in previous stages of assembly. Left corners used boxes to the right - the inner corner, connecting the apron to the wall. The upper part of the panel has been wound up for the edge of the bathtub, thus creating the effect of "incorporation" and giving the whole structure a graceful appearance.

Screwing various air vents and hatches and enjoy the results of their work, I completed work. By the next visit I plan to give final touches bathrooms. That he was a "turnkey" I will establish a plinth, attach the toilet to the floor, attach bath to the sewerage system by siphoning process and sealant joints with walls, hang the curtain under the shutter and a holder for toilet paper.

On that channel everyone can share its experience in the construction, repair and improvement of your home, suburban area, send photos, tell me about your country, house, apartment. And we will tell you about my little house on the canal. Information and photos (preferably horizontal) send to [email protected]

construction history, repair, arrangement of housing, land, interior design, landscape design, cottage - helpful tips and ideas. Subscribe to the channel - in front of a lot of new and interesting information!