From the apartment in his house. Inzhenerki: heat management

Budget Automation in the heating system in a wooden house

I hasten to say:

1. I am for complete automation and smart home.

Well who in their right mind, give up convenience to open the phone, looked that your house is going on, if necessary, corrected, adjusted. You never know what, it's about the accident notification, and so on. D.

The beauty! Which as always costs money.

2. Money on beauty no other task is complete, and at nedokrasotu do not want to spend. We live constantly, minimizing management costs - I'm the controller itself.

Hence the thought.

The basis of any heating system - the temperature in the system carrier.

medium temperature can be higher than - air warms up faster or below - the air will be heated more slowly. But with any version of the air eventually warms up and the boiler must be switched off. For this purpose, any system has an external thermostat, set in some control room. This is where a person is given temperature, above which the thermostat disables the boiler.

This is where all the equipment from the most simple to the complex. It would seem that a carrier of high predetermined temperature and let thermostat disconnects. Impossible. T. e. within certain limits - yes but exactly carrier temperature will vary with air temperature outdoors 0, -15, -30, or accident.

So at the start, we have two adjustable components:

1. TMP carrier.

In our house, I regulates.

It has long been reduced to a straight line depending on the outdoor temperature:

0 degrees = 50 degrees street coolant and more -1 = +51 ...- 10 = +60... -20 = +70. I do not run every morning or evening, not to twitch. The house is warm, inertial system, but if I hear that in the next days the outdoor temperature changes by 5 degrees - go and put up on the boiler.

The temperature was exposed, and further includes a temperature sensor disables-boiler according to the air temperature.

2. Air temperature.
But the question is - where it is measured, immediately complicates the situation.

Ask a question about his household, what is important to them in the heating?

The answer is: comfort. They are not interested in media temperature batteries, they do not want the air temperature is neither hot nor cold.

They want a comfortable temperature.

And what comfort? And it turns out that it is at everyone.

As a result, we should have:

• T 1 - for common premises: living room, kitchen. A certain average temperature in which all coexist simultaneously or wearing wool socks, or stripped down to T-shirts.
• T 2 - for non-residential: a pantry, closet, hallway, guest bedroom.
• T 3 - bathroom, shower room.
• T 4 - 1 bedroom, where his wife and 25 cool, and I'm dying.
• T 5 - bedroom 2, for mom, and wherein at +20 hot.
• T 6 - the eldest daughter in-law - let them understand.

Hence, it is necessary to regulate the temperature in every room. The easiest option:

Thermal head valves on radiators.

Suffice economical, and most importantly, it is absolutely a working solution. According to his passport put in position, let it be 22 in the room. Who is cooler - fasten who warmer - unscrew.

Based on this we get an answer to the question of where to stand off the boiler sensor. boiler temperature sensor should be in the room where it will be the highest and is set to the highest. Moreover, in this room should not stand thermal head. Variants of "cheating" is, but we are now working on the simplest decisions.

Actually all. The system works by itself is very well regulated. The sun peeped out of the window, the temperature in a particular room rises, the thermal head is covered, consumption decreases, tank line in a shorter course comes faster, the boiler is switched off. And vice versa. In terms of comfort, all will be almost exactly.

Come back to us. It seems like a thermal head and each has its own temperature. But no, once again the human factor. His wife (my mother) should be, well, that's just it is necessary to:

• see the current temperature in the room;
• regulate it.

No, of course you can bellow (gently), or in the end to try to teach to tighten the thermal head (yeah with distantsionnikami to a TV sometimes a problem, but here ...), but you know - not. And he adds:

Servo.

The same thermal head, but adjustable remote own temperature sensor, usually have quite presentable.

I bought at a sample of one set. Put in operation the dressing room, where until recently when the red on the street to keep the temperature +10 without the inclusion of battery. Thinking, I expose 12 (right), to observe how the system will work. Temperature "walks" from 11.5 to 12.5. It works as expected. Put in the bedrooms, I hope the problems add-subtract from relatives will not occur.

Again the nuances!!! There are such things: normally closed, normally open. On my example: If the actuator is not energized, it opens completely (normally open). I'm from a small gasoline generator powered only boiler room, but the house is living, the battery warm. If necessary the actuator "normally closed", it means that no voltage is completely closed and the battery to cool down. We must all be taken into account. Again, if there is a gasoline generator required power is connected to the house - then it does not matter indoor, outdoor...

Servo and put in the sewers, including underfloor heating. There is a battery-powered actuators. There are controlled remotely. T. e. I went automation. Servo remotely communicate with temperature sensors. The sensors transmit information to the system controller, on which comes the information carrier and the temperature and the outside temperature and other stuff. All this flow of information is reduced to clear graphics, easy electronic buttons and transmitted over the internet to phones and computers, where we add, diminish, expose regimes, shorter manageable.

And yet controllers - going legs and adjustable handles.

I want to add a review on underfloor heating. Very well, very nice. With reference to the arrival of granddaughter, from Friday evening to Sunday evening we include heated floors in the hall and the kitchen, where most of the time everything goes. Radiators, by the way, I have to disable this period - missing floors.

Previous post - Networks: boiler room, nuances.

Next post - engineering networks: remote control light system.

More stories - in the thematic section.

Subscribe to the channel. Share in social networks. Join FORUMHOUSE.