Probably, it is necessary to correct to call the article "How to elevate the well." But dig a well, and to me ennobled.
How to elevate the well
Aesthetics well
We had an old well, which was a 7 concrete rings, dug into the ground. Next to buried two rings of wooden pillars of oak, that kept the gates, and which drew water from the well. Cover at the well was not, it was replaced by 6 rotten boards that fell, and could fall a cat between them, which once happened.
As I wrote, upgrading the well has not been determined a necessity, just had to take the time at the time of idle construction crew, which was engaged in the construction of the gazebo.
Building material (logs of wood) in the area was, rather, were logs, which are left over from the construction of baths and a pair of metal pieces, which remained from the bath.
So the fact that it was my builders blinded... chic well.
The size of the well, ie, log of 140 cm x 140 cm. Height 80 cm. This is one polubrevno and 4 full crown of logs.
Because load wreaths on the foundation is not very big, we decided not to make additional formwork and pour concrete. For the foundation took the red brick building and laid out in two rows on a sandy base. Prior to that leveled the ground around the well, having gone deep 20 cm.
On bricks laid waterproof tape, which was used in the construction of the gazebo, it put polubrevno.
water lifting device traditional system. Gates, which rests on two supports. The roof is modeled on a well-built house, ie the usual truss system.
Under rafters stacked film sheets are laid on rafters Pural matt metal M 28.
Total time on the design of the well, in view of sawing logs into bowls, boring holes for Nagel installation of pillars and roof system is gone, or shaky, or rolls, for about 4 hours.
After lunch, the roof covered with sheets of metal. Portion immediately transformed.
Then he made blind area, and ennobled the remnants of the stone. Left to paint and construction ...
Serves this building for several years, only once painted.
What is the cost to make a beautiful well. On this question there is no answer. If it did on order, as defined by the foreman of builders, the cost of such a well would be no more than 15,000 rubles (including material).
By the way, we have a well, about 35 meters, the water from there as all... Now, well water enters the house: Dishwasher, stiralka etc. Rust as from a well on porcelain there. Because the water in the well defended and the metal is deposited on the bottom. But more on that later.