How to make decorative baskets on the jig machine

About such a basket I was told earlier in the channel, for example, here.

At this time I offer to see how to do the simplest decorative baskets. At the end of the article, you can also download a template of such a basket and try to do it yourself.

These baskets can be made of flat do dosochek wood hardwood, such as oak, beech, ash. Or plywood. Billets previously sanded desirable.

To get started on the workpiece is pasted template. Stick a variety of ways: someone is doing this by printing a pattern on self-adhesive paper, someone first paste masking tape, and then the pattern. I use building PVA. Building because it is poorly glues and template later easily removed.

Before sawing drill the necessary holes to cut the pattern and the basket ring.

Because the rings in this basket is quite thin, so as not to make them even thinner, hole saws have been made with the shift.

And then sawed figure in the center and all the rings baskets series. The procedure of sawing define as you wish.

When the sawing is completed, the template is removed paper. Next on the rings slightly chamfered in a circle.

Next, cut portions are glued together into a finished product.

There can be successfully PVA glue joiner's glue, after drying it provides a solid and transparent connection.

The adhesive is applied droplets on the inside bends of the Rings. Rings are glued from the inside to the outside, turning so that the internal curves lay on top ring outer lower bends.

After drying, the adhesive article is varnished and ready to use.

The entire sequence of manufacture can be seen in the video clip.

Download a template for cutting out of a basket can be here.

Thank you for reading. I will be glad of your support in the form of a husky and a subscription to the channel. And look for other posts on the channel.

Alexander.