Milling on the circular saw.

milling process using a circular saw has long been known.

Different people realize it differently. Someone makes the frame of the parallelogram type, someone using rail, fixed at an angle against the rip fence. I apply for this method simply bar fixed on the saw table clamps.

The principle of this method is to feed the workpiece at an angle to the saw blade. From this angle, the depth of cut and diameter of the disc depends form obtained after milling.

For a more complete picture of how depends obtained from notch angle, the diameter of the disc and the cutting depth, look at the website material Mathias Wandel - it's here.

Rate this form may be looking end view of the blank positioned behind the saw blade.

When the angle of the support bar relative to the disc turns out another form.

The saw blade is not originally intended for such a work that may be milled only 2-3 mm in one pass and the desired depth is obtained for a few passages.

How to setup.

To set up, you must first put the disc in the full depth and milling as in the photo above to evaluate the desired angle.

Then the support bar set at the desired distance - measured perpendicular from an upper tooth disc to the support bar. It will be a center, receives the samples.

That is, if you need to get a sample of the middle part of 60 mm in width, install the support bar 30 mm from the top of the tooth drive.

Further omit the saw blade so that it is above the surface of the table out on 2 mm - for the first pass - and frezeruem.

Next, lift the disc 2 mm and make another pass. And so until we get the desired depth.

Milling on the edge of the part.

The same method can be milled edge parts. To this end, the edge of the supporting bar must be placed directly on the saw blade.

The cutout in the bar will help in this.

Next disc also raise the required depth of milling and measure the distance from the bottom tooth of the saw blade to the bar.

This will be the edge width obtained.

Further, also in several passes frezeruem edge part.

It turns out that's a result.

Conclusions.

This method is quite simple and it can be done, for example a plinth - like here. Or making panels for facades.

For example, here are the facades were made in this way.

Thank you for reading. I will be glad of your support in the form of a husky and a subscription to the channel. And look for other posts on the channel.

Alexander.