Board "screw". How to align and used for ceiling beams?
Ideal building material, probably will not happen. So we must proceed from the fact that there is.
During the whole period of my building, I have often faced with poor quality materials.
And apply the strange sand
And the bad block used
and much more on the little things.
And now it's time for the tree.
❗ Of course, I expect that this material will be difficult.
- High-quality cut - is a rarity.
- Storage conditions are satisfied sellers unit.
As a result, we have a problem. But even in these situations, you can do something.
🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹🔹
When I set the joists on the large span needed to make it reinforced. Here I took one curve and one normal board 50 200.
To begin, I pulled them in several places with screws, in the hope that the level of the board will be more strength. But the curvature of the edge.
The resulting beam ❗ became twisted screw.
We had to think of something else ...
Solution was simple.
To begin, I leveled and firmly fastened one end of the beam, the second at the same time to get a decent cluttered.
Now would align the edge you need. But a thick beam, hands only, it is difficult to twist. I went as follows:
- Nailed to a beam of the board, which is needed as a lever.
- Secured area on the beam itself.
- Then, this lever is easily flattened beam and nailed.
Although then I thought, and realized that it was easier to just pull screws through the corner. I think it would have happened.
✅ In any case, the main thing that the result can be obtained from, not quite, high-quality wood.
But of course, I needed a careful approach to the choice of wood. But this issue we will return ...
💥Subscribe to KANAL💥and put layki👍. Construction is moving forward.