Lintel above the openings. As I have simplified a job?
When building a house alone, then we have to take this into account when planning a variety of workflows.
Making jumpers is no exception. In one of the articles I wrote that I decided to fill the bridge in placeAnd not to have finished.
it was a decision due to the fact, all you need to do the same.
❗ But in this case has its own nuances, and they are connected with the process of preparation of the formwork under the bridge.
Bottom part.
I did decking boards from 25 to 100, knocked together by the width of the wall. And secured in the opening by the same board.
But the problem isThat bring this flooring perfectly with the plane number of aerated concrete does not work. Boards are not perfectly flat and not perfectly uniform in thickness (but 1st grade).
✅ This caused problems with masonry blocks this opening.
Side wall formwork.
I decided to make their blocks of 100 mm on both sides, and the remaining 100 mm in the middle, pour the concrete. (wall thickness 300 mm).
Here was a problem and lay out a series of evenly over the span of such a narrow block.
And I try something to enclose under them, and the right to put on the glue, but everywhere one difficulty - align, and move to in the future. In general, anything not normally go.
And then, I to the head I came ideya.👆
I glued the blocks separately on the adhesive foam(directly on the wall, next to the openings, so as not to pick it up later), And received, as it were, the beam is more or less direct and important pillaredThat you just need to put on the openings.
❗ Strength-foam adhesive was enough to make all not collapsed during installation.
The only thing was hard on one large opening, it turned the beam of the four blocks. And the rest were put very simply.
Zaarmirovat left and pour concrete.
✅ So that the construction - it's always creative processAnd the use of new solutions that are convenient in a given situation.
🔹SUBSCRIBE TO THE CHANNEL🔹 and put the Huskies. The process continues ...