Decorative partitions. How to make your own hands.
Recently I finished making just such a decorative partitions for zone separation space of the room.
It is made of a plurality of bars of 40x40 mm 40h20 mm. It was possible to attach a lot of short clippings that have accumulated in the workshop.
Dimensions of the partitions 2520h1300 mm installed it in thrust: floor ceiling.
Build walls was often conducted on dowels. The main instrument for additives holes for dowels served homemade filler router.
First, we mark up all the details, and then drilling. On some holes the bars had to be done on both sides, so you had to be very careful not to get confused. Although three small bar still had to be replaced due to errors.
Assembly septum done element by element.
First collect small pieces. Then larger. This project turned out to be exactly the case when the clamp is never too much.
When the assembly had to comply with certain sequence, then all of the rose as needed.
it was actually a large frame with a completed interior. The bars of this big frame I put on the dovetail.
First, I gathered all the internal components. Next, put them together with the vertical bars.
This vertical detail collected sequentially from one end to another, gradually tightening the clamps.
Then I installed a large horizontal bars of the frame and began to paint.
Dyed using a color gun aqueous varnish. Consumption of varnish to make small, but did a lot of layers. After each intermediate layer polishing.
As I said at the beginning of the partition was mounted in thrust. For the lower leg brace bar installed nut. Hole under it done by the smaller size of the nuts and pine bar is pressed into the nut with a clamp. the way withamodelnaya quick-clamp of mounting sealant gun, showed a greater force than the factory.
The upper horizontal bar pasted small plates made of plywood so that they rested on the ceiling.
The ceiling in the apartment, where to put the partition was the tension and place settings are pre-made mortgage beam to stop.
Lift to the eighth floor turned out to be a bit difficult. Partition itself is not heavy, but the turn around on the stairs proved difficult. The staircase in the house is made separately from the apartments, and elevator and the size of 252 cm is not passed on the landings had to raise the partition and expand diagonally.
And it makes for a good friend, and she was pleased with the work.
There is also a video clip from the production sequence.
Thank you for reading. I will be glad of your support in the form of a husky and a subscription to the channel. And look for other posts on the channel.
Alexander.
P.S. We also invite you to your site.