A simple way to make thin strips and wedges on the circular saw
When there is a need to cut thin strips, the method proposed below may well help.
You just need to make the pusher of the type, as proposed here. Only for him to have to take dosochki with parallel edges and a minimum width of the palm. And use this pusher is necessary, pressing against the rip fence.
With this end dosochki need to tie any suitable rail.
Next, the pusher must be applied to the rip fence and adjust the thickness of sawn planks.
Now you can not change the settings to cut the right amount of equal thickness strips.
The same method can be cut into many of the same wedges for dosochki only need to take a pusher wedge.
With the narrow end of the strap is also screwed.
Then you can easily to saw right wedges.
The same way you can do slants on the legs of chairs and stools.
For clarity, I suggest to look a little video.
Thank you for reading. I will be glad of your support in the form of a husky and a subscription to the channel. And look for other posts on the channel.
Alexander.
P.S. We also invite you to your site.