Scratches and damage is inevitable! How do I solve this problem on its roof.
I thought that I would do everything carefully.After work, it became clear that this was not possible. But how then to be with all the injuries of metal?
The photo is not the result of my work, but the result of improper delivery of metal (this I wrote this article). But such lists had to be used.
But this is not important, what will be discussed.
β Even if you imagine that I would have brought the material in perfect condition, still, after the installation, would be damaged. And these are the main reasons for their occurrence:
πΉ sheet stacking process.
"Neatly, bolted, that is so tough." - I thought I'd never having to do with it. But in practice, at the same from the first sheet, there were many difficulties. (About them, I wrote this article).
And one of them was that sometimes had an awkward position to work, and to shift several times, and even lead assembly is not quite standard, and slip one under the other sheets (About this, You can be read here).
β All this inevitably led to the contact sheets to each other, and as a result scratch.
πΉ Disruptions screwdriver.
article "1750 twisted roofing screws. I thought - this is the easiest fixture. As it turned out in practice? "I described all the details of his work with fasteners. And one of them was part of the screw falling off during tightening.
So, what I flew screw - it's little things. And the fact that each such failure, withccompanied blow screwdriver, metal, It was a major drawback. Scratches get serious ...
πΉ Dirty shoes.
"Wear soft shoes!" - spoken in all the installation lessons. And how to make sure that it does not fly skazano.π
I do not know, like everyone else, but I'm in the area and the earth and sand, all of it sticks to the soles. And on most metal, it works as an image.
Of course I tried to shake off the excess, but a perfect result, you still do not get it. And as a result, obtained small but scuff metal.
But all of this is achieved by the presence of one simple thing.
Balloon with paint for metal - it is an integral part of the installation process.
Moreover, it is not necessary to put off until later, as a separate operation.
β I scratched, painted over and forgotten.
Therefore, the balloon was always with me in my pocket.
And exactly the same color as the metal itself, I have not found (sheets - dark-brown color, and the color chocolate brown).
When only the color, the color is different of course, but when dry, the difference is minimal.
β On the ground it at all noticeable.
Of course, this is not a 100% protection, but still better than nothing, and yet somehow protects damage.
π₯SUBSCRIBE TO THE CHANNELπ₯, and put the Huskiesπ. Important is your assessment of my work. π