Simple things you can not miss. My revision before installing the metal.

Sometimes, the simple nuances depend all subsequent construction process. Once again, I convinced that in construction there are no trifles.

In the last article, I wrote, both struggled with the attacking natureAnd purified his crate of snow, which is so "unexpectedly fell in late autumn"(Sarcasm... 😎).

Now it's time to start the work.

Why I did not put the drip edge, fascia boards and hooks under vodostochku, I explained in this article.

✅ Today we will focus on the fact that I still decided to install. On the whole process in the amount I spent only a few hours (given that one was doing everything for the first time). But from the silent work, it depends on all subsequent installation of metal, and in general the proper functioning of the roof.

❗ And the main thing, then - it will be very difficult to finish, or to correct ...

Ventilation grid.

This is the thing that was very simple.

Gradually unwinding, I attach it to the board at the groundworks for short screws in a wide flat hat. Easier to nowhere.

In the normal course tedious and secured top and bottom. But as for me, overhangs are not fully completed (fascia board will be attached later), The lower edge of the left free. But it does not interfere and does not affect anything.

❗ But this simple meshIn the future, will not start in a ventilated gap no living creatures, such as insects and birds. And it affects, roof ventilation, and hence its longevity.

Compensating rail.

This item was as follows. Although many do not know what it is and why you need.

✅ The bottom line is that the lower edge of the metal, is attached to the overhang. And if the roof over the whole surface, it comes to the crate bottom of the waves, the extreme, the lower board reaches the top of the wave. And to ensure that metal does not "dive" into this place down, you do thickening. Option two:

• Immediately place the bottom board crates thicker.
• Or add to an existing one.

I went through the second.

Circular saw cut off from the board 50 to the desired 200 to 15 mm, I got the desired item.

It remains only to fix in place. Of the difficulties of the snow it was here that had to clean off.

Well, the final touch - Cornice strip.

I never thoughtBut most of all I promuchalas, tearing off her protective film.

I used this I came across. And I do not know whether the cold, she lags badly, or whether it should be, but in the end I long her "oshkurival" than mounted on place.

All installed on the cord, as it is not hoped for evenness batten boards.

❗ A straight line is important hereSince by this, will build the whole styling metal.

Everything is ready, and you can proceed to the main point.

Although to be honestAnd then, I still remember all this simplicity and ease of the work. Still come out one downside, which will have to suffer. But it's a different story ...

💥SUBSCRIBE TO THE CHANNEL💥 and put huskies 👍. Advice and recommendations will be glad too 😁.