7 ways to use a drill for drilling NOT

Drill is often the first tool in the home studio, and when I was a teenager, I dreamed of an electric drill, because it's so much you can do ...

Next, take a look how you can use a drill for other purposes, that is not for drilling.

The first method.

Perhaps the most obvious. Electric drill, you can tighten the screws, and if there is a reversal, then twist.

Second.

Using the drill for the grinding plane. There are two variants of nozzles on the drill: a flexible nozzle and cap with Velcro.

To use flexible nozzles required skill. Drill with this skill can be removed more material than the belt sander. For coarse grinding fits well.

Another tip works well at low speeds, and it can help to polish the already fine sandpaper, and a smooth surface.

Third.

Drill can act as a small grinder.

For grinding edges and ends, rounding radius for such a solution is quite suitable.

Fourth.

As for grinding again. This method can be useful in many cases.

Pro manufacturing such a grinding drum see here.

Fifth.

In fact I do not recommend the use of a drill, but still an experience I had.

This use of a drill as conveyers.

Such a nozzle for a drill, in which you can hold down the drive, I bought on the market in the late 90s. And even a little sawed drill. Only it necessarily need to firmly consolidate and make the saw table.

Sixth

Again, this is not the best use of the drill, but when there is nothing else, it is possible to use it.

The snap disc I clamped saw blade for grinders. And I had an experience with a drill sawing a piece of spring, from which I then made a wide chisel.

About this chisel see here.

Seventh

Often, a drill is used as a lathe for small products.

How this can be done quickly and easily see here.

In addition.

I suggest to watch a video where told about the nuances of using attachments for grinding plane.

Conclusions.

It's certainly not all methods when the drill is used for other purposes. If you look on the network, such as Aliespress, you can find a variety of different attachments to drill... for sharpening drills to make the jigsaw, grinding machine, etc.

And I am personally very rescued drill to tighten the screws, grinding, and for the manufacture of small turned parts.

Thank you for reading. I will be glad of your support in the form of a husky and a subscription to the channel. And look for other posts on the channel.

Alexander.

P.S. We also invite you to your site.