I put the rafters with his hands. A lot of mistakes, and the reasons I do not understand?

What is so difficult: measurements, washed down, put... So I thought until I came to the point.

And once again, I am convinced that the practice of any work, is crucial. What is the foundation that the masonry walls, I constantly got out moments which is not written anywhere, and not to make a video. And many are not ready, how many do not examine information only while you learn the truth!

✅ And what, then, the more I begin to understand the "builders - experts" who promote professionalism in the construction site, and against such samostroyschikov like me. But in my defense I will say that in my opinion:

The one who made mistakes, corrected them and learned how to be better than someone who knows and can do, but makes anyhow-how.

So I continue to learn by doing ...

And now the next important stage - the truss system.

I already wrote, how to put the rack under the ridge pole and I did jib. It's time to put yourself rafters.

• Pictures were selected boards 50 to 200.
• Step rafters 625 mm in the center, under the insulation.
instagram viewer
• To reduce the bursting stress, I decided to put the rafters with gashes on both ends.
• The layout for the installation of the rafters to the ridge, I did advance, and mauerlat, they will be adjacent to the joists, installed under the same dimensions.

Everything is ready, only to throw ...

❗ But the most important task is to do everything as accurately as possible.

Already on his experience in the previous steps, I was well aware that irregularities mauerlat and skating run, uneven rafters themselves, and "Kryven'kyi hands" novice, can not lead to the ideal plane roof. But to make as accurate as desired.

Templates do not come to me.

Of course everyone wants to streamline and simplify your work. And to make a template, and on it is all the rafters - this is the easiest option.

But for all of the geometry of the walls, and mauerlat ridge pole, must be perfect.

✅ try this system, I realized that I do not fit the ideal.

• If on one edge of the house was a small discrepancy.

• At the other are already significant.

And if the bottom - this is not particularly critical, the top was more of a problem as it was necessary to dock the rafters joint to joint.

In general, so I put extreme rafters and the middle, and decided to go through a little more complicated.

• Between the rafters at the top and at the bottom I pulled the laces.

• putting then each rafter feet to the place of installation, mark the places gashes.

• Then rafters cleaned and measured the distance to lace up and mauerlat ridge run (The entire length of the house, these values ​​jumped within 8 mm).
• And it is already measured out the distance from the rafters themselves.

In theory everything should work perfectly.

But in reality it turned out, too, with shoals.

I then and now do not understand how this could be... But still did not turn out perfect joints.

Maybe something shifted when marking may zapilivaem crooked, do not know. It will remain a mystery.

But in the end it was that happened, and there is no place to disappear from it.

If the estimate by eye, the plane turned out good. But laces, she walks up to 5 mm. And how will it affect the clutch metal, also know in practice. But it seems to me that this stuff.

By the way, I ask experts to write your opinion in the comments. Should I worry about this?

💥SUBSCRIBE TO THE CHANNEL💥 and put the Huskies. Another big step is completed ...