Simple home-made with ample opportunities. As it has done. details

IN a recent publication I'm talking about homemade stanochke with ample opportunities. In this article I will discuss about the structure of various components of the homemade.

Fixing the flexible shaft

I'll start with the flexible shaft attachment.

Here, I use long nut. One end of the tip-boiled sanitary hose. What kind of hose not remember, but the tip is threaded diameter suited for this M10 nuts. Thread pitch was smaller, but the metal is brass, so that it was possible to screw.

Inside the hole drilled to 6 mm, just to fit the flexible shaft. On one face of the drilled hole and for fine threaded screw.

The end of the shaft is securely clamped in the nut modernized, but it is already screwed onto the shaft and fix stanochka konrgaykoy.

Engine

Further engine. This is a Chinese motor from a washing machine semiautomatic. In appearance, I found it on the Internet - is the engine of a series of xtd-60,90,120. I did not understand exactly how it turns. In one place there that in 1200 about \ mines, and other oddly written - 1350 \ 1600.

The engine is attached to the plywood piece, and one corner of the part is bolted to the body, so that the engine under its own weight fell and pulled the belt on the pulleys.

Shaft 12 mm engine. Pulleys densely clothed him, and by the splines on the shaft of the screw is screwed.

Raising and lowering the engine is easy to throw a belt on pulleys.

Shaft with pulleys

Now about the mounting shaft with pulleys in stanochka housing.

As the shaft using threaded rod M10. For mounting of the shaft in the walls of the housing drilled holes for bearings.

The opening on the one hand equal to the diameter of the bearing and a depth equal to its thickness, and on the other hand is made smaller, but so that the washer and the nut, wherein the bearing is clamped, freely rotate.

The bearing shaft is clamped on both sides of washers and nuts. The holes on the chassis is inserted very tightly. In addition, the second nut on the shaft bearings Contra.

For greater clarity, I suggest to watch the video clip.

In addition.

In comments to last publications sounds that engage in this nonsense, and easier to buy a drill.

I understand that it is often people write poorly familiar with the subject, and this can mislead readers interested, so I will try to clarify some points.

I have bormashinka type "Dremel" and it is well suited to sharpen the saw or cutter, or cut and grind anything made of metal. Working with wood is also possible, but far from all sorts of mills and in the grinding of wood, it just burns with large turnovers. At low speeds the same bormashinku can stop fingers.

A demonstration of how this occurs can be seen in the video clip of another article on this channel.

The same stanochek sanding wood fits very well, and Bor at the maximum speed you can work normally. A stop arms this machine is difficult even at low revs.

Also in this homemade it is possible to extend the functionality.

As you can see from these instruments are somewhat different tasks.

Thank you for reading. I will be glad of your support in the form of a husky and a subscription to the channel. And look for other posts on the channel.

Alexander.