L-shaped stop for the conveyers. Trimming chamfer.

IN last article I talked about a little-known fence for circular saw.

At this time I offer to see how it can be used to trim the chamfer on the details.

Recall that generally L-shaped stop is used together with the template. And in the case of chamfer trimming pattern will be very detail.

Take the example of the chamfer with an angle of 45 degrees.

First you need to make some adjustments. L-shaped stop is set so that the item has rested against the upper edge.

the saw blade is installed with a slope of 45 degrees, and the outer edge of the disc is held line from which to measure the magnitude of the bevel.

C 45 mounted size will be cut with a plane and the edges. If the saw blade tilt angle to choose another, the chamfer is not equilateral.

To chamfer was cut completely drive is necessary to raise as much as possible, but it does not touch the face.

After setting up, you can safely cut the chamfer.

Thus it is possible to cut and chamfer small, almost the entire thickness of the part.

Ease of use of the palm trimming chamfers that once set up, and can "run" part of any form.

Thank you for reading. I will be glad of your support in the form of a husky and a subscription to the channel. And look for other posts on the channel.

Alexander.