Useful content

How to make a simple and reliable stool. Part 3. we do tsargi

click fraud protection

The previous article in this series, see here.

Before you do milling in the legs it makes sense to saw blanks drawer side and make them milling.

Side-bar can be made from planks of 20 mm or furniture board. Pine board typically has a thickness of 18 mm.

Let me remind you that the side-bar to do the size of 220h70 and initially cut enough of them only in length - 220 mm, and after milling trim width. Wide billet mill will be more convenient.

When cutting height disk install a couple of millimeters greater than the thickness of the workpiece. So to cut a lot safer.

After cutting blanks for cylinder shells turn to their milling. Here I am using a small cutter Dovetail. The height of the cutter 10 mm, diameter 9.5 mm.

I install the cutter in the router and I adjust the height of the desk height cutter - 10 mm.

As a milling machine, I use hand-mill set in the table.

Lateral support of the router is set by the depth of the cutter blade. That is, the abutting face in the preform cutter knife and pushes abutment.

instagram viewer

Initially, Fraser probe to check the setting.

If the blank test result differs from the planned, the setting is adjusted and checked again.

Depth turned out as it should.

Spike dovetail turned out as planned.

Now it is possible to mill all the blanks for cylinder shells.

Remind milled workpiece drawer side with the ends and sides. On drawings It is shown.

The following publication is shown as milled dovetail groove, Studable, which is made on the drawer side.

Thank you for reading. I will be glad of your support in the form of a husky and a subscription to the channel.

Alexander.

P.S. The next part.

As I Heated workshop during the cold season.

As I Heated workshop during the cold season.

Question heating shop in the cold season, everyone decides on his own. I will share how it happen...

Read More

What is a sandwich construction and what it eats?

What is a sandwich construction and what it eats?

In this article I will tell you what sandwich panelsWhat are the main types of sandwich panelsThe...

Read More

The most common variants of decoration of the facade of the house of aerated concrete

The most common variants of decoration of the facade of the house of aerated concrete

Hello, friends! Today will tell you about the decoration of the house of aerated concrete, as man...

Read More

Instagram story viewer