How easy to make stand for tablet or phone?

Hello! Recently I had the need to make a stand for the tablet, so you can normally shoot video, because in your hands, no matter how hard you try, it is still a little camera shake, and because of this reduced quality video. In today's article I would like to share with you as much as possible of the available tools to quickly and easily make a simple stand for your tablet or phone. With this tripod is very easy to shoot video, because the device is fixed and the camera will not shake.

In order to make a tripod, you will need four bolts and nuts, two elastic bands, a pair of small screws, and preferably six goals.

Plywood or board (I did of 20 mm plywood) will need to cut it out four rails, two rails of length 30 - 35 cm and two rack 15 cm. In general, the length of the slats depends on how high you need a tripod, so your dimensions may be different. In addition to the rails still need to saw stand, which will be fixed by the tablet. In a stand to make holes for the camera and a small slot on the edges of the top and bottom for the gums, so they will not move out.

Next, you need to drill holes at the edges of the rails bolt. That they were free to better drill bit to drill a larger diameter. In long rails drill holes in the two edges, and in short only one.

You should get something like this:

Now you need to connect the rail bolts and tighten the nuts (in place of the nuts is certainly better to use thumbscrews, but I did not have them). Preferably under the bonnet bolts and nuts washers enclose, then they will not crash into the wood. Assembled in such a way that the edges have been short rail. One will be installed stand for the tablet, and the other will be fixed on a table or chair.

Then any short rail screws fasten the stand and put on her gum, which will be attached tablet.

In the end, you should have a tripod here.

While I fixed tripod with the bolt on the back of an old chair unnecessary. In the future I will update this tripod, and be sure to share with you my modifications. Plans to remove gum and come up with another method for attaching the tablet to make fasteners for the table and replace the nuts on the lambs, for easy fixing. But, as long as even a simple tripod copes with its function.

That's all. If my article was helpful for you then put the Huskies and do not forget to subscribe to the channel "Podelkin".