As I did the casket for needlework.

This box is not done just so, and as a gift.

Wife asked to do something interesting on the birthday of his girlfriend. I thought about it and offered to box.

I was interested to try to make a box with three power tools and their accessories - those were elektrorubanok, circular saw mounted on a table and sander. Such is the experiment.

Photo boxes

The result is such a box. Material - beech.

It consists of four departments. Outer cover tilts on hinges.

And from three small drawers.

Basic fabrication steps

The starting material for the manufacture served unedged beech scaffold.

First leveled plane of the board via fittings planer. On it was it previously. Received planed board of 42 mm thick.

Then the circular saw to cut it to a width of 11 cm and then dissolved into thin dosochki and 7 to 11 mm. This is also done on the circular saw. After planing the workpiece 10 received and 6 mm thick.

But beyond these details dosochek sliced ​​boxes. Wide parts glued in two parts.

On the side walls, facades and the bottom 10 mm dosochki used. In the boxes, the top cover and the bottom of the intermediate part 6 went mm thick.

Wall boxes and boxes glued on mustache. Under the intermediate bottom groove made on circular saw.

The entire assembly was placed on the adhesive. Used Class D3 PVA.

Accessories take in the local shops for hobbyists.

If you need more details, then they are in the video:

In general, everything turned out just as well pleased with the result. (And his wife and her friend. Of course and I got... Thanks :))

Thank you for reading. I will be glad of your support in the form of a husky and a subscription to the channel. Write comments - Your opinion is important.

Alexander.