The results of using raw boards. Bug fixes.
Working with wood has its own characteristics and complexity, To be aware and take account of them in advance. One of the criteria is wood humidityWhich may change, and change the geometry of the wooden structures.
I ran into this when he made a fence on the site.
For this I used the board 100h25 mm. On the site I had introduced them at the beginning of last summer, and began to use only in the autumn. And though I covered their film (apparently poorly covered), Most of mokla from rain all the time.
And at the time of use of the material I was very raw.
In fact, it would not matter much to the fence, as I board is attached in a staggered manner. The only thing on the gate and the gate, they had to be fastened in the joint together.
I knew perfectly well that the board dries, cracks and will have it as something to correct. So I each board is attached to metal screws one at the top and bottom, with the expectation that you have to redo everything.
And so it turned out.
Hung on the fence the whole winter, the board significantly dried up, that the at the gate it was very noticeable.
In addition to slots, some boards twisted "screw", so that threw up some screws.
Now I had to redo everything. If the gap were small individually, the sliding boards together turned total clearance of about 5 cm. And instead of a narrow board crept wide.
Now I could finally consolidate all.
In general, it seems to me that it is better than the fence boards all have not dried up anyway. And try to dry them somewhere under cover in the yard - it waste of time, Still does not normally happen.
So remodel it would have had a greater or lesser extent. And knowing this beforehand, you can greatly reduce a job.