My building. Warming of the floor.

Flooring and insulation - is the next stage of my development. It was launched on 30 August and 14 September to about finished.

By this time, my building has looked like this:

Floorboards I also first polished. Stack them as well as on the ceiling: a full-length rows, but is not sawed in half, and fasten the four meter.

Logs stack by 60 cm - the size of a heater. The longest lag I have left 360 cm.

Here, I made a mistake - considered that such a length is sufficient to base a log only at the edges. It really was enough, but... this floor a little playing, that is, small fluctuations up and down when walking. At this distance, it was necessary at least to make more support for the lag in the middle, but rather through two 1.2 meters.

Warming of the floor I was doing pretty simple:

I stapler lag between the insulating film and nailed to it is placed around the two sheets of insulation, turned by 10 cm. A heater that I used quite easily, so the film on its brackets held.

I will also spread out on top of the film and then stack the board.

For long curves boards I used the following styles: curve board inserted in the groove previous board and screwed to a pair of lag, then consistently pressed board and fixed the next, when it is not strong enough to squeeze his hands, then crepes on a log and temporary stop already with the lever booster board.

Of all the boards 5-7 could not be so secure, so much they were bent.

Also, for the sake of completeness I propose to look a little video on this construction phase.

Completion of construction is getting closer. In the next issue on this topic will be on the ceiling and electrical insulation.

Previous materials on the subject of my building:

My building. How to clean the ceiling and zabivshuyusya nazhdachku

My building. Economical paneling.

As I built the house. Wall insulation.

Subscribe to the channel. Put huskies and write comments.

Alexander.