How to make a long clamp for a few minutes.

In the manufacture of joinery, there are occasions when you need to pull things overall. For example, glue the shield more than a meter or pull the door leaf in the assembly.

If long clamps in the economy there, they can help out a couple of bars and a handful of screws.

I tell the example gluing shield. I needed to work shield width of 110 cm. In the presence of crop were 80 cm and less. Here's one I decided to glue. To be safe, in addition to the glue I decided to put more dowels. With the help of a homemade prisadochnika it turns quickly.

On the device home-made filler router can be found in this article - Homemade filler router. Device

For clamps took two bar section of approximately 60x40 mm. On one edge trimmings screwed pair of planks. The second side is also similar dosochki fastened only at a slight angle and at a distance of a couple of centimeters longer than the width of the board.

For tightening clamps used in such wedges, so the second guides are screwed at an angle to the wedge fits tightly. Then simply prepared details, stacked on the bars.. a pair of blows with a hammer on the wedge and secure all compressed.

Such clamp I have used for tightening door. It turns quickly and convenient.

Also this principle tightening wedges well-behaved show with carpeting to pull the board. On the joists screwed bar and wedge attracted board. Board nailed or screwed, the wedge was removed and can then be laid.

The carpenter's shop many clamps does not happen, they are always in need. There are a few publications on the clamps.

Clamp with a clamp stop. Blueprints.

Classical carpentry clamp. Device.

Universal workbench workshop. The story of

About workbench - it's not really about the clamp, but it is also possible to clamp the parts for machining.

Thank you for reading and... until the next publication.

I will be glad of your support in the form of a husky and a subscription to the channel.

Alexander.

On a note:

All articles of this channel is based on materialsmysite -"Joinery"